Operation - Velleman VTHD07 Bedienungsanleitung

3. Description
A. chuck
B. spindle
C. on/off switch
D. rotation speed display
E. rotation speed increase button
F. rotation speed decrease button
G. shaft lock button
H. wrench
K. housing cap with shaft
4. Attaching an Accessory to the Drill
Always disconnect the electric drill from the mains prior to attaching/changing an accessory. Never press the lock
button when the electric drill is operating.
Loosen the chuck (A) using the
wrench (H) and simultaneously press
the lock button (G).
5. Mounting the Flexible Shaft
Loosen the chuck (A) using
the wrench (H) and
simultaneously press the
lock button (G). Remove the
housing cap (K).

6. Operation

Select the proper accessory for the proper job. Press the on/off switch and choose the rotation speed with buttons (E) or (F).
We recommend a lower setting when working with plastics or for polishing. Depending on the job, hold the electric drill like a
pen (drilling, engraving...) or like a hammer (milling). Always switch off the electric drill after use.
VTHD07_v2
Check that the spindle (B) fits the
diameter of the accessory's shaft (2.5
or 3.2mm).
Place the 3.2mm spindle
(B) and insert the flexible
shaft.
Insert the spindle and retighten the
chuck (A) while pressing the lock
button (G).
Tighten.
4
Fix the flexible chuck (L) by
tightening with a hex driver
(M).
VELLEMAN