Cleaning The Feeder; Important Notice; Advice For Use - Zummo Z14 Bedienungsanleitung

Insert the blade in the squeezer tray and slot the ribs into the grooves of the balls. Check that the

blade slides easily.
Assemble both Juice tray and Blade in the machine's three shafts simultaneously. Never fit the

Blade on the Juice tray afterwards!! To introduce the Blade into the Blade shaft, slightly
press down the Blade push it into the shaft. ATTENTION!!! Never press down the metal part
of the Blade.
Fit the Front Cover in place by fitting its clasps into the slots. Make sure that the clasps fit correctly

into the slots. You will hear a small click.
Put the Plastic Bins Base and the Plastic Bins in place.

Before operating the machine, make sure that:
 Juice tray and Blade are properly fitted in place.
 Fastening Nuts are properly tightened.
 The correct set of squeezing parts (Balls, Cups and Fruit Selector) are fitted. (see
"Accessories" in this manual).
If Blade, Juice tray, Balls or Cups are not correctly assembled, serious damage may be caused to
these parts or to the interior components of the machine.
(Z14 Model) The display will show the number of oranges to be squeezed. The machine is now ready
for operation.
(Self-service Model) When the machine is ready to work, the display show the "machine icon and the
orange icon".

Cleaning the feeder

Unscrew the Nut located inside the basket. (Fig. 13)

Remove the Hopper Fruit Classifier pulling it upwards. (Fig. 14)

Remove the Hopper Basket pulling it upwards until it is completely removed from the shaft. (Fig.

15)
Remove the Hopper Track.

Clean all parts with soapy water or using a dishwasher machine.

Reassemble the parts as follows:
Assemble the Hopper Track,

Fit the Hopper Basket onto the shaft ;

Turn the Hopper Basket clockwise until it gets locked. The pins should have entered into their

respective holes.
Assemble the Hopper Fruit Classifier into the Hopper Basket until it gets locked into place.

Screw the Basket top nut.


Important Notice

The normal use of the machine may cause the plastic parts that are exposed to juice to turn orange colour.
This is completely normal and does not imply a hygiene problem or affect the physical properties of the
plastic.
SELF SERVICE MODEL:
formed plastic. They must not be subjected to temperatures higher than 40°C, so they should never be
washed in very hot water or in a dishwasher; if they are deformed by heat, the warranty will not apply.

5.7. ADVICE FOR USE

 Always make sure you are using the right squeezing set of Balls, Cups and Fruit Classifier for the
size of fruit you wish to squeeze. If the fruit to squeeze is too big or too small for the squeezing kit
used, the quality of the juice may decrease, resulting in a bitter juice flavour.
 The Hopper Fruit Classifier must be correctly selected according to the size of the fruit to squeeze.
 If fruits are too large for the Fruit Classifier, the fruit will not fall into the Cup. If fruits are otherwise
too small, numerous pieces of fruits will fall at the same time into the Cup.
 We recommend to switch off the machine when is not in use. (Fig. 3)
22
(Operator faults not covered by the guarantee)
Refs. 1402017 drip tray and 1409001 faucet tray, are made from heat-