Switching Off; Commissioning - IKA Vacstar digital Betriebsanleitung

Observe the operating instructions
NOTE
for the devices.
Check if the voltage specified on the type plate matches the avail-
able mains voltage. If these conditions are met, the device is ready
for operation when it is plugged in to the mains.
Switching on
1. Switch on the device using the main switch (D). All display
sements are shown to enable a visual check.
2. Software version number display (e.g. vers. 1.00).
3. Operating mode display (A; B). (Factory setting: Operating
mode A)
The operating mode can be changed when you switch on the
device.
Operating mode A:
In this operating mode, the set target value is not saved when
the current run comes to an end or the device is switched off.
No automatic restart after mains power is cut off.
Switching on with several interfaces
If the pump is operated via the analogue connecting cable MVP
10.100 with the vacuum controller VC 10 or the rotary evaporator
RV 10 auto, "VC 10" is shown on the display.

Switching off

Switch off the device using the main switch (D).
26

Commissioning

The socket used must be earthed
(grounded contact).
Unplug the appliance from the
mains socket to disconnect it from
the mains.
Otherwise safe operation is not guaranteed or the device may be
damaged.
Observe the ambient conditions indicated under "Technical data".
Operating mode B:
In this operating mode, the set target value is saved when the
current run comes to an end or the device is switched off, and
the value can be changed.
Operating mode B is required particularly in combination with
the pump cut-out unit VC 2.4.
Automatic restart after mains power is cut off.
Changing operating mode:
1. Press the rotating/pressing knob (C) and switch on the
device at the main switch (D) at the same time to change
between the two operating modes.
In standalone operation or two-position operation in combination
with the vacuum controller VC 10 the target speed can be set by
turning the rotating/pressing knob (C). Push to start the pump and
push again to stop it. A flashing light on the display (B) indicates
when the device is running.
If the vacuum controller is connected to a PC, "PC" is shown on
the display (B).