Hydraulic System Requirements; Typical Layout; Performance Charts - Ramsey Winch RPH 111,2 Bedienungsanleitung

Refer to the performance charts below to properly match your hydraulic system to the winch performance. The
charts consist of: (1) Line Pull first layer kN (lb) vs. Working Pressure bar (PSI). (2) Line Speed, first layer MPM
(FPM) vs. flow LPM (GPM).

HYDRAULIC SYSTEM REQUIREMENTS

1. Motor spool (open center) control valve
2. Emergency Stop:
A. If winch is controlled by a direct-operated manual valve, that valve serves as the E-stop.
B. If a remote operated control valve is used, a solenoid-operated hydraulic dump valve, normally open to
tank, and an emergency stop switch (to open the dump valve) is required. The E-stop switch is to be
normally closed and have a red, resettable push button actuator with a yellow background. The E-stop
switch must be easily accessible to the operator.
3. Relief valve set to 207 bar (3000 psi) which is the rated capacity limiter.
4. Flow rate of 56,7 LPM (15 GPM) maximum. Do not exceed 75,7 LPM (20 GPM) or motor and winch may be
damaged.
5. Hydraulic fluid with a viscosity between 20-43 cSt (100-200 SUS). Maximum operating temperature 85C
(180F). Cleanliness level of ISO 17-14 or better.

TYPICAL LAYOUT

MOTOR
BRAKE
PORT

PERFORMANCE CHARTS

7,6 (25)
6,1 (20)
4,6 (15)
3,1 (10)
1,5 (5)
0
0
(0)
FLOW LPM (GPM)
BASED ON 157 cc (9.6 cu in) MOTOR
DUAL-A & B PORT CONTROL
WITH BRAKE RELEASE SHUTTLE
18,9 37,9 56,7
(5) (10) (15)
PROVIDED BY USER
HIGH PRESSURE LINE
12,7 mm (.50 in)
I.D. MINIMUM
3 POSITION
4 WAY VALVE
(MOTOR SPOOL)
*
REQUIRED ONLY IF REMOTE-OPERATED CONTROL VALVE IS USED. SEE 2B
IN HYDRAULIC SYSTEMS REQUIREMENTS. NOT REQUIRED FOR A
DIRECT-OPERATED MANUAL VALVE.
111,2 (25,000)
89,0 (20,000)
66,7 (15,000)
44,5 (10,000)
WORKING PRESSURE bar (PSI) AT 56,7 LPM (15 GPM)
2
LOW PRESSURE LINE
19 mm (.75 in) I.D. MINIMUM
*
DUMP VALVE
PUMP
MAX. FLOW &
PRESSURE AT
RATED LOAD:
56,7 LPM (15 GPM)
207 bar (3000 PSI)
*
E-STOP SWITCH
SYSTEM RELIEF
207 BAR (3000 PSI)
(RATED CAPACITY LIMITER)
0
0 68,9
(0) (1000)
137,9 206,8
(2000) (3000)