Bridge Function; Automatic Heat Up; Power Function - AEG HKL65310XB Benutzerinformation

4.4 Cooking zone indication
min.
max.
The horizontal line shows the maximum
size of the cookware. The break in the
horizontal line shows the minimum
cookware diameter.
Refer to "Technical information" chapter.

4.5 Bridge function

This function connects two left side
cooking zones and they operate as one.
First set the heat setting for one of the
left side cooking zones.
To activate the function: touch
set or change the heat setting touch one
of the control sensors.
To deactivate the function: touch
The cooking zones operate
independently.

4.6 Automatic Heat Up

If you activate this function you can get a
necessary heat setting in a shorter time.
The function sets the highest heat setting
for some time and then decreases to the
correct heat setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch ( comes on).
Immediately touch the correct heat
setting. After 3 seconds
To deactivate the function: change the
heat setting.

4.7 Power function

This function makes more power
available to the induction cooking zones.
The function can be activated for the
induction cooking zone only for a limited
period of time. After this time the
induction cooking zone automatically
sets back to the highest heat setting.
To activate the function for a cooking
zone: touch
To deactivate the function: change the
heat setting.
4.8 Power function of the
double ring cooking zone
The function is activated for the inner
ring when the hob senses the cookware
with a smaller diameter than the inner
ring. The function is activated for the
outer ring when the hob senses the
cookware with a bigger diameter than
the inner ring.
4.9 Timer
. To
Count Down Timer
You can use this function to set how long
the cooking zone should operate for a
.
single cooking session.
First set the cooking zone then set the
function. You can set the heat setting
before or after you set the function.
To set the cooking zone: touch
again and again until the indicator of a
necessary cooking zone comes on.
To activate the function: touch
the timer to set the time (00 - 99
minutes). When the indicator of the
cooking zone starts to flash slowly the
time counts down.
To see the remaining time: set the
cooking zone with
the cooking zone starts to flash quickly.
comes on.
The display shows the remaining time.
To change the time: set the cooking
zone with
To deactivate the function: set the
cooking zone with
remaining time counts back to 00. The
indicator of the cooking zone goes out.
Refer to "Technical
information" chapter.
. comes on.
. The indicator of
. Touch or
and touch
ENGLISH 9
of
.
. The