Electrical Connection - Electrolux TG05012 Benutzerinformation

1
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the nat-
ural fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The Af-
ter Sales Service specialist will carry out
the reversibility of the doors at your cost.

9.5 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
1
2
2
3
• Remove the screw fixing the lower door
hinge and the other screw fixing the
lower door hinge and the foot. Then re-
move the door hinge and the foot as
shown in the figure.
• Loosen the screw fixing the foot oppo-
site the lower door hinge in order to re-
move the foot.
• Fix the door hinge and the correspond-
ing foot on the opposite side and then
the other loosened foot at the former
place of the door hinge as shown in the
figure.
• Make sure to place the lower foot be-
low the door hinge. The lower foot is
recognizable by its 4 ribs on the outer
surface.
• Fix the door onto the lower hinge pin.
• To fit top door hinge, remove the plastic
blanking plugs carefully, and refit them
in the holes left by the hinge retaining
screws.
• Refit the top hinge using the 2 retaining
screws, taking care that the edge of the
door is parallel with side of the cabinet.
• Replace the hinge cover.
• Relocate the handle and the plastic
plugs to the opposite side.
• Level the appliance, wait for at least
four hours and then connect it to the
power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
The appliance must be earthed. The pow-
er supply cable plug is provided with a
contact for this purpose. If the domestic
power supply socket is not earthed, con-
nect the appliance to a separate earth in
ENGLISH 59