Door Reversibility - Electrolux TG05012 Benutzerinformation

58 www.electrolux.com
9.3 Location

9.4 Door reversibility

A
~10 cm
~2,5 cm
1
2
4
The appliance should be installed well
B
away from sources of heat such as radia-
tors, boilers, direct sunlight etc. Ensure
that air can circulate freely around the
back of the cabinet. To ensure best per-
formance, if the appliance is positioned
below an overhanging wall unit, the mini-
mum distance between the top of the
~2,5 cm
cabinet and the wall unit must be at least
100 mm . Ideally, however, the appliance
should not be positioned below overhang-
ing wall units. Accurate levelling is ensur-
ed by one or more adjustable feet at the
base of the cabinet.
If the cabinet is placed in a corner and the
side with the hinges facing the wall, the
distance between the wall and the cabinet
must be at least 10 mm to allow the door
to open enough so that the shelves can
be removed.
WARNING!
Make sure that the mains plug is
accessible after the installation of
the appliance.
To carry out the following opera-
tions, we suggest that this be
made with another person that will
keep a firm hold on the doors of
3
the appliance during the opera-
tions.
To change the opening direction of the
door, do these steps:
• Remove the plug from the power sock-
1
et.
• Remove the top hinge cover.
• Unscrew the 2 retaining screws, and
remove the hinge from the appliance.
• Take the door off.