End Of Product Life; Troubleshooting - Sunoptic Surgical Titan 400HP S400T Bedienungsanleitung

equipment subject to misuse, accidental damage, normal wear and tear or if transferred to a
new owner without authorization from SUNOPTIC TECHNOLOGIES
specific legal rights and you may also have other rights that vary from state to state.
POST WARRANTY REPAIRS: You may return your product(s) for repair, shipping prepaid to
the factory. Your product will be inspected and an estimate of repair charges will be submitted
to you for approval.
In the US:
•
FAX number:
•
• Customer Service
9.

END OF PRODUCT LIFE

In accordance with the European Waste from Electrical and Electronic Equipment (WEEE)
directive, we encourage our customers to recycle this product whenever possible. Disposal
of this unit must be performed in accordance with the applicable local environmental
regulations.
In the US a list of recyclers in your area can be found at: http:/www.eiae.org/.
Please contact customer service to issue a return authorization to return product to
manufacturer at the end of product life.
10.

TROUBLESHOOTING

Problem
The lamp switch (refer to 4.1)
is not lit.
The lamp switch is lit, but
Xenon lamp will not ignite.
LIT124SUNOPTIC SURGICAL
(English)
877-814-2237 (toll free)
904 733-4832
904-737-7611
Solution
A. Check that the AC power cord is properly
connected.
B. Check the circuit breakers. If necessary,
reset.
C. Power input switch is in the off position
A. Check to make sure lamp cartridge is seated properly.
B. Check that the lamp door is secured.
C. Check hour meter; if lamp hours exceed the rated lamp life,
replace the lamp (refer to 9.1).
®
®
. This warranty gives you
Rev. I
Date of Revision: 02/08/16
Page 11 of 66