3 Electrical Requirements; 4 Unpacking The System; 5 System Installation; 6 Power Cord Connection - Cavitron JET Plus Gebrauchsanweisung

7.3 Electrical requirements

• Incoming power to the system must be 100 volts AC to
240 volts AC, single phase 50/60 Hz capable of
supplying 1.0 amps.
• The system power should be supplied through the AC
power cord provided with your system.

7.4 unpacking the System

Carefully unpack your Cavitron JET Plus Combination System
and verify that all components and accessories are included:
1. Cavitron JET Plus
®
Handpiece Cable Assembly with swivel
2. Air Line Assembly (Black) with Filter and Quick
Disconnect
3. Water Line Assembly (Blue) with Filter and Quick
Disconnect
4. Additional Water Line Filter
5. Detachable AC Power Cord (not shown)
6. Wireless Foot Control Assembly
7. "AA" Batteries (4-Pack)
8. Auxiliary Cable for Foot Control
9. Cavitron JET Air Polishing Insert with cleaning tool
®
10. JET-Mate Detachable Sterilizable Handpiece
11. Prophy Handpiece Cleaning Wire (not shown)
12. Cavitron Ultrasonic Inserts (quantity optional)
®
13. Efficiency Indicator for Cavitron Inserts
14. Literature Packet
15. PROPHY-JET Sodium Bicarbonate Prophy Powder
®
16. JET-Fresh Aluminum Trihydroxide Prophy Powder
®
(may not be included in all kits)
17. Powder Removal Container

7.5 System Installation

• The Cavitron JET Plus Combination System is designed
to rest on a level surface. Be sure unit is stable and
resting on four feet.
• Placing unit in direct sunlight may discolor plastic
housing.
Combination System with
™
• The system has been equipped with a wireless foot
control which was factory synchronized to operate with
the system's base unit. If your office has more than
one Cavitron JET Plus system, it is recommended that
you mark the foot control and base unit for easy
reference as to which foot control operates with which
base unit. Should resynchronization be necessary, follow
the instructions in section 7.10.

7.6 power Cord Connection

• Verify the Main Power ON/OFF switch, located at the
center front underside of the System, is set to the OFF
(O) position before proceeding.
• Insert the AC power cord into the power input on the
back of the System.
• Insert the pronged plug into an AC wall outlet.

7.7 water Supply Line Connection

• Grasp the Water Supply Line (blue hose) by the end
opposite the quick-disconnect and insert it into the water
inlet connector until fully seated.
• Connect the quick-disconnect to the dental office water
supply or a Cavitron DualSelect Dispensing System.
• Inspect all connections to make certain there are no
leaks.
• To remove the water line from the Cavitron JET Plus
7