Instructions For The Installer; Installation; Electrical Connection - Glem FM60TMIX Gebrauchs- Und Wartungshandbuch

en

2. installation

2.1 electrical connection

Ensure that the voltage corresponds to that indicated in the plaque located on the oven door frame.
The cables for the connection to the mains must be protected from direct contact with the oven's metal casing.
the plaque must never be removed.
attention: the ground connection must be compliant with law.
if using a fixed connection, it is necessary to interpose a 4000v insulating category switch which assures the
omnipolar disconnection of the built-in oven from the mains.
this switch must be installed inside the fixed plant according to the laws and standards in force.
avoid using reductions or adaptors as they may cause overheating or burning.
After installation, carry out a brief oven check, following the instructions reported further down.
In case the appliance does not function, disconnect it from the mains and contact the after-sales assistance centre nearest to you.
do not attempt to repair the appliance.
attention:
the manufacturer declines every responsibility for damages suffered by persons and things, caused by the non
compliance of the above prescriptions or deriving from the tampering of even a single part of the appliance and the
use of non original spare parts.

instructions For tHe installer

34