Switching On For The First Time - auna 10032044 Bedienungsanleitung

SWITCHING ON FOR THE FIRST TIME

When the unit is connected to the AC power for the first time, it will be in
standby mode, the display will first show "00:00:00" and then go to off.
Press the STANDBY/FUNC button once to turn the radio on, it will then
automatically enter into the DAB mode and perform auto scan function.
AC operation
1. Connect one end of the AC power cord to the unit and the other end to
the AC mains outlet.
2. Press the STANDBY/FUNC button once to turn the unit on and it would
automatically enter into the DAB mode.
3. During unit operation, to switch the unit to standby, press and hold the
STANDBY/FUNC button for long than two seconds.
DC (battery) operation
In DC operation, the STANDBY/FUNC button will work as a Power On/Off
button. The display will be totally off when the radio is powered off.
1. Ensure the AC power cord is disconnected from the radio and AC mains.
2. Installed the batteries (8X1.5V C Size battery) into the battery
compartment.
3. Press the STANDBY/FUNC button to toggle the unit between on and off.
Note: To obtain the best performance in DC operation, the use of alkaline
batteries is highly recommended.
Setting the Clock
The clock can only be set in AC standby mode. When the display is off in
standby, press on the PLAY/PAUSE or STOP button once will turn on the
display to show the clock for around 10 seconds. To perform the clock
setting:
1. Ensure the unit is in standby, press the PLAY/PAUSE or STOP button
once to turn on the display, then press and hold the PRESET/CLOCK
SET button until the display shows "24H" and flash, press the TUNE- or
TUNE+ button to select the "24H" (24-Hour) or "12H" (12-Hour) clock
display format, when your desired format appears in the display, press
the PRESET/CLOCK SET button to confirm.
2. The display will show the clock with the hour digits flash, press the
TUNE- or TUNE+ button to the correct hour followed by pressing the
PRESET/CLOCK SET button to confirm - first set the hour and then the
minute.
3. When the display shows the correct time, finally press the PRESET/
CLOCK SET button again to confirm.
EN
25