ASSEMBLING AND ADJUSTMENTS
Assembly of drill motor
IMPORTANT! Always pull out the plug from the outlet
socket before cleaning, maintenance or assembly.
•
Always remove the drill bit before the motor is mounted or
dismounted.
•
Lock the feed housing lock.
•
Mount the quick mounting on the drill motor.
•
Mount the quick mounting and drilling machine in the track
on the locking clamp. Make sure that the quick-mount is
pushed all the way to the bottom (A) of the rail on the
locking clip.
•
Fasten the locking clamp with the locking screw (B).
Adjust the column tilt
The column can be tilted 0-60°.
•
Loosen the locking screws for column tilt and set the
desired drill angle. Tighten the locking screws.
•
The angle indicator can be used for approximate
adjustment. If higher precision is required, alternative
measuring methods should be used.
Before drilling
WARNING! Before drilling, check that all
!
locking screws are tightened well.
Serious accidents can occur if the concrete
core remains in the drill when backing out
the drill motor/drill from the floor, wall or
ceiling.
WARNING! When drilling roofs, always use a
!
water collector that is approved for your drill
motor, or use a hydraulic drill motor. There is
a risk that the drilling machine and the stand
become live if water leaks into the machine.
– 9
English