Initial Use; Use - Beurer FC 49 Gebrauchsanweisung

7. Initial use

Charge the device for at least 2 hours before initial operation. To do this, proceed as follows:
1. Insert the mains cable into the charging socket on the rear of the facial brush.
2. Insert the USB plug to the mains adapter and connect this with the mains socket.
3. Whilst charging, the white LED light in the transparent base of the facial brush will flash.
4. When the battery is fully charged, the LED light will remain on.
Note
When the battery is low the device will flash 9x and then turn itself off.
IMPORTANT
Do not use the device while it is charging!

8. Use

1. Moisten the FC 49 facial brush with water. Never use the device while it is dry, as this can irritate
the skin.
2. Apply the cleansing gel to your facial skin.
3. Press the ON/OFF button once to switch on the device. The LED light will briefly flash 3x and the
facial brush will begin to vibrate.
4. The device has a total of 15 intensity levels and when turned on, will begin to vibrate at a moderate
speed setting. To switch between the individual intensity levels, press the + / - button. The LED
light will briefly flash 3x each time the intensity level is changed.
5. Now apply the device gently to your face and cleanse your face using even movements. For cleans-
ing the delicate skin around the eyes, use a lower intensity level. The coarse cleansing surface can
be used for both cleansing oily skin, as well as massage.
6. After use, switch the device off by pressing the ON/OFF button once. The LED light will again flash
3x and the device will turn off.
7. Cleanse your face thoroughly with water to remove any residue from your skin.
8. Pat your face dry with a towel and then apply a moisturising cream using even, circular movements.
IMPORTANT
Stop use immediately if use of the facial brush leads to reactions, and consult your doctor.
17