miniland baby humitouch pure Bedienungsanleitung Seite 16

ENGLISH
5.8. ADDING ESSENCES (Figure 4)
If you wish to add essences (not included), take out the tray of the essence compartment
(10) and pour enough essence on the sponge for it to be soaked (approximately ten
drops). Put the essence compartment back in its position.
NOTE:
• When it is cold, the windows and even the walls could fog up or allow frost to develop
due to excessive interior humidity. If this happens, reduce the adjustment (I, or II on
the remote control) of the vapour intensity to avoid damage due to the condensation
of the water.
• An excess of humidity in the room can cause the humidity to gather on the surfaces
where it could encourage the growth of bacteria and fungi. The accumulated humidity
could also damage the furniture and walls, especially wallpaper.
• In order to correct excessive humidity, especially in a small room, leave the door of
the room open and adjust the intensity of the vapour.
5.9. TROUBLESHOOTING
SYMPTOMS
The humidifier
does not work; it
releases neither
air nor vapour
The vapour has
an unpleasant
smell
The vapour has
no essence
The empty water
tank warning
lights up, but the
water tank is full
CAUSE
It has not been connected
to the power supply
The humidifier has not
powered on
The water tank is empty
The water tank is not
correctly positioned on
the base
The humidifier is new
The water is dirty or has
been stored in the water
tank for a long time
No essence has been
introduced or the sponge
is too dry
The water tank is too full
The water tank has not
been correctly positioned
on the base
ACTION
Connect the humidifier to the
mains network
Power on the unit by pushing
the button
Fill the water tank
Make sure to correctly position
the water tank on the base.
Check that some air bubbles
appear when placing the water
tank on the base
Open the water tank and air
it off in a cool, dry place for
twelve hours
Clean the water tank and fill it
with clean water
Add essence to the
compartment until the sponge
is soaked (approximately ten
drops)
Empty the water tank a little and
put it back in position
Remove the water tank and
put it back in position correctly.
Check that some air bubbles
appear when placing the water
tank on the base
16