miniland baby digimonitor 3.5 plus Bedienungsanleitung Seite 35

Problem
There is no reception
on the monitor
No images are shown
but sounds are heard
Images are only shown
in black and white
The parents' voices
cannot be heard on
the baby unit
The camera is not
transmitting
The baby cannot be
heard on the parents'
unit
Interferences or
unsatisfactory reception
It is not possible to
charge the battery
on the parents' unit
Possible Cause
The VOX mode is active
The monitor is out of range
The connection has been lost
between the monitor and a
camera which is already
connected.
The monitor battery charge is
low (check the LED indicator)
Check whether the camera is
in the night vision/"infrared"
mode
The adjustment of the baby
unit volume is too low
The Camera has not come on
Camera: The AC adapter has
not been plugged in
The VOX mode is active
The adjustment of the parents'
unit volume is too low
The sensitivity adjustment of
the baby unit is too low
There are mobile phones or
wireless phones too close to
the baby monitor
The AC/DC adapter has not
been plugged in
A non-rechargeable battery
has been used
ENGLISH
Solution
To see the monitored area
continuously, you must
disconnect the VOX mode
on the monitor.
Bring the monitor closer
to the camera
Pair the camera with the
monitor again
Plug in the AC adapter or
charge the battery
To see the images in colour,
increase the light at the
placwhere the camera is located
Adjust the volume to the
highest level
Press and keep pressed in
the button (II) for 2 seconds
Plug in the AC adapter
To see the monitored area
continuously, you must
disconnect the VOX mode
on the monitor.
Adjust the volume to the
highest level
Increase the sensitivity level
adjustment of the baby unit
Keep the phones away from
the device
Plug in the adapter to an
electric socket
Only rechargeable batteries
can be used (3,7 V – 1200mAh
Li-ion battery). test the battery
and, where necessary, change
it for the one supplied with the
appliance