TECNOINOX EFP08M Anleitung Seite 12

To convert the appliance to another type of gas, e.g. from natural gas to
LPG, the nozzles of the main burner need to be replaced.
All the nozzles are marked with a number that indicates the diameter in
1/100 and are supplied in a bag.
After each conversion or adaptation, the appliance must undergo an
operating test and the supplementary plate must be updated according
to the conversion or adaptation carried out.
All appliance connection, installation, and maintenance
operations must only be carried out by qualified technicians and in
compliance with all applicable regulations!
Access the valve and the burner for any conversion or adjustment by
removing the right side panel (fig 1.1).
Replace the nozzle | U | (fig. 7) with a suitable one for the new type of
gas, see the "nozzle table" in the technical data section.
The transformation from one gas to another also involves the
adjustment of the valve output pressure, which can be detected with a
U pressure gauge (definition min. 0.1 mbar) that can be connected to
the pressure outlet (fig. 8).
Conversion and adjustment to a new type of gas
Fig.7
Fig.8
Use screw B (fig.9) to adjust the pressure; the reference values are
indicated in the "nozzle table".
 B - external hex screw adjusts the maximum pressure
EN - 4
Fig. 9