ROWENTA PRO PERFECT Gebrauchsanleitung Seite 9

on the steam control button to obtain
short bursts of steam, without placing
the iron on the garment itself.
This will avoid making the fabric
shiny. Steam output control dial
setting: Thick fabric: increase the
steam setting. At a low temperature:
set the steam output control dial to
the low position. For delicate
fabrics(•), press the steam control
button (under the handle of the iron)
intermittently to avoid possible water
droplets appearing with the steam.
Do not place the iron on a metal
support. When taking a break from
ironing, always place the iron on the
iron rest plate of the unit. It is
equipped with non-slip pads and has
been designed to withstand high
temperatures.
6. Use the steam turbo
Set the humid steam control to suit the
user (iron held with left hand or right
hand).
Press 2 or 3 times briefly on the turbo
steam control - fig. 9 to get an occasional
burst of steam iron for ironing heavy
fabrics, eliminating creases or for more
powerful vertical steaming.
ATTENTION! Use the steam turbo
function with great care because the
extraordinary power of the steam can
cause burns.
7 • Vertical steam ironing
Set the iron temperature control and the
steam output control dial (located on the
control panel) to the maximum position.
Hang the garment on a coat hanger and
hold the fabric slightly taut with one
hand. Press repeatedly on the steam
- fig.8 control button (beneath the iron
handle) moving the iron from top to
bottom - fig.10.
Examples of how to use the vertical
steaming function:
• Removing creases directly on hangers
from delicate fabrics that you do not
want to bring into contact with the hot
iron.
• Refreshing a shirt or a suit just before
putting it on.
As steam is very hot: never attempt to
remove creases from a garment while
it is being worn, always hang
garments on a coat hanger. For fabrics
other than linen or cotton, hold the
iron a few centimetres from the
garment to avoid burning the fabric.
8 • Dry ironing
Do not press on the steam control
button.
9 • Fill the water tank again
When there is no more steam and
the"Water tank empty" light flashes
fig.11 : water tank is empty .
Remove the water tank using the handle
(on the front of the steam generator)
fig. 12 and fill it
the Max. level.
If this occurs, remove the excess
water.
Push the water tank into position until it
"clicks" into place. Press the Restart
button underneath the control panel.
The steam generator and the iron are
ready for use when the steam indicator
light is on and the iron indicator goes
out.
10 • Storing the steam
generator
Press the illuminated on/off switch O/I
and unplug the generator. Place the iron
on the iron rest on the steam generator.
Fold the steam cord in two and place it in
its housing. Leave the steam generator
to cool for at least one hour before
putting it away if it is to be stored in a
5
- fig. 1 do not fill above
EN
-
-