Operating The Control Panel; Using Your Steam Generator - ROWENTA PRO PERFECT Gebrauchsanleitung

USE
3 • Switching on your steam
generator
Press on the on / off switch
begins flashing. The green light (located
on the control panel) flashes and the
boiler heats up.
When starting, and regularly while it is
being used, your steam generator's
electric pump injects water into the boiler.
It makes a noise but this is quite normal.
The steam generator and the iron are
ready for use when the steam indicator
light is on and the iron light goes out.
The first time the appliance is used,
there may be some fumes and smell but
this is not harmful. They will not affect
use and will disappear quickly.
4 • Operating the control panel
• Flashing green light
heating up in the boiler.
• Continuous green light
ready for use.
• Continuous red light
tank is empty.
• The "Calc-Away
indicator flashes
needs to be rinsed.
5 • Using your steam
generator
Place the iron's temperature control
fig.5 to the type of fabric to be ironed and
set the steam output
temperature control light turns on.
T
YPE OF
FABRIC TEMPERATURE CONTROL
S
YNTHETICS
(Polyester, Acetate,
Acrylic, Polyamide)
S / W
ILK OOL
C /
OTTON
L
INEN
- fig.4, it
- fig.6 : the water is
- fig.7 : steam is
- fig.11 : the water
System" orange
- fig. 13 : the collector
- fig.6. The iron
S S
ETTING ETTING STEAM
CONTROL
• • •
• •
•
ECO Mode: Your steam genera-
tor iron has an ECO mode func-
tion which uses less power*
whilst still guaranteeing a suffi-
cient steam flow for you to iron
your garments properly. In order to use this
function, once the thermostat of your iron
has been correctly set (see table above), po-
sition the steam flow setting on the ECO
segment. The ECO mode can be used on all
types of fabrics, nevertheless for very thick
or very creased fabrics, we recommend that
you use the maximum steam flow for best
results.
While ironing, the light on top of the iron
and the steam ready light turn on and
off, as the temperature adjusts without
interrupting ironing. To obtain steam,
press on the steam control button
beneath the iron handle and keep it
pressed - fig.8. The steam will stop when
you release the button.
Always spray starch on the reverse side
of the fabric to be ironed.
Recommendations: To prime the
steam circuit, either before using the
iron for the first time, or if you have
not used the steam function for a few
minutes, press the steam control
button several times in a row - fig.8,
holding the iron away from your
-
clothes. This will enable any cold
water to be removed from the steam
circuit.
Iron temperature control setting: Start
with fabrics to be ironed at a low
temperature and finish with those
which need higher temperatures. Each
time you change fabrics, wait for the
light to turn off. Mixed fibre fabrics:
set the ironing temperature to the
setting for the most delicate fabric.
Woollen garments: press repeatedly
4