Kaiser S 45 70 XL Gebrauchsanweisung Seite 16

3
2
1
4
5
7
6
16
3
2
1
After that it is necessary to fix the panel on a door
of a dishwasher by screws from the inside of the
door through corresponding holes 3.
For this purpose:
7
The door springs are set at the factory to the
proper tension for the outer door. If aesthetic
wooden panel are installed, you will have to adjust
the door spring tension. Rotate the adjusting screw
6 to drive the adjustor 7 to strain or relax the steel
cable.
Door spring tension is correct when the door
remains horizontal in the fully opened position, yet
rises to a close with the slight lift of a finger
EN
The hook is lifted from position 1 to the
appropriate place, and then pushed right to
the position 2, making the panel and the
outer door align.
Take away the cover 4,
Pin up the screw 5,
Get back the cover.