Connection Notes - Siemens SIPROTEC 4 7XT34 Produktinformation

6

Connection Notes

6.1 Overview
The device has two 4-pole 600 V terminal blocks with tension sleeve.
✧ Ground the device at the grounding areas with low resistance and low
inductance.
✧ Establish the connections via the screwed terminals. Pay attention to the
labeling, permitted conductor cross-sections, and bending radii.
NOTE
Screwed terminals can be used without bootlace ferrules.
Do not use any pin-type terminal lugs.
✧ The terminal screws are screwed tight upon delivery. Release the terminal
screws before inserting the connecting cable into the terminal chamber.
Figure 6-1 Standard Terminal Variant
✧ Strip the connecting cable to the stripping length specified in Chapter 6.2 using
suitable insulation strippers.
8
SIPROTEC 4, 20-Hz Band-pass Filter 7XT34, Product Information
C53000-B1174-C130-5, Edition 09.2016