Maintenance - JB Systems DYNAMO 250 Bedienungsanleitung

ENGLISH
decode.
 How to set the DIP-switches to obtain the right starting address:
On the back of the Dynamo you will see that each of the first 9 DIP-switches corresponds to certain
value:
Dip #1
Value 1
You can combine the values of these switches to become any starting address between 1 and 512:
Begin address = 01
Begin address = 05
Begin address = 09
Begin address = 13
Begin address = 62
 DMX-CONFIGURATION:

MAINTENANCE

 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
JB SYSTEMS
®
#2 #3 #4
2 4 8
 switch 1=ON
 switch 1+3=ON
 switch 1+4=ON
 switch 1+3+4=ON
 switch 2+3+4+5+6=ON
#5 #6 #7
16 32 64
values: 1
values: 1+4 = 5
values: 1+8 = 9
values: 1+4+8 = 13
values: 2+4+8+16+32 = 62
5/41
OPERATION MANUAL
#8 #9
128 256
DYNAMO 250