– must not be used for animals;
– must not be used when damp.
– When the electric underblanket is switched on
– no object (e.g. bag or washing basket) must be placed on it;
– no source of heat such as a hot-water bottle, heat pad etc. must be placed on it;
– the switch must not be covered by blankets, pillows etc. or be placed on the blanket.
– Do not pull, twist or sharply bend the cables.
– Do not pierce the electric underblanket with needles or pointed objects.
– This heated underblanket should only be operated with the switch indicated on the device (label).
– This electric underblanket must not be used by children unless the switch has been preset by
their parents or carers, or the child has been adequately instructed in how to use the electric
u nderblanket.
– The electric underblanket must be checked frequently for signs of wear or damage. If any such
signs are found or if the blanket has been improperly used, it must be sent in to the manufacturer
or dealer before it is used again.
– Repairs must be carried out only by skilled persons or a repairer authorized by the manufacturer,
as special tools are required. Improper repairs can result in considerable danger to users.
– If you have any further questions concerning the use of our products, please contact our customer
service.
2. Proper Use
This electric underblanket is intended for warming beds. The electric underblanket heats up best
when it is switched on when covered with a quilt. The heating up time with the electric underblanket
covered is approx. 30 minutes. You can use either side of the electric underblanket.
3. Operation
3.1 safety
This heated underblanket is equipped with the SAFETY SYSTEM. This electronic sensor technology
prevents the entire surface of the heated underblanket from overheating by automatically switching
off in the event of a fault. If the safety system switches off the heated underblanket automatically as
a result of a fault, the indicator lamp is no longer illuminated even when the heated underblanket is
switched on. Please note that, after a fault has occurred, the heated underblanket can no longer be
used for safety reasons and must be sent to the service address indicated.
3.2 Putting into Operation
Spread out the heated underblanket flat on your mattress so that the cable entry is
located at approximately shoulder height (see illustration). The head section is not
heated.
Then pull the side section over the sides of your mattress like a fitted sheet. The
underblanket is designed to fit mattresses in sizes 35x80 in (90x200 cm) and
38x80 in (100x200 cm).
Then secure your fitted sheet as usual so that the heated underblanket is between
your mattress and the fitted sheet.
Make sure that the heated underblanket is always spread out flat and does not
ruckle or crease after use. Check its position when making the bed. The heated
underblanket should only be switched on if it is spread out flat. We recommend
switching on the underblanket approx. 30 minutes before going to bed and cove-
ring it with the quilt to prevent the heat from escaping.
Attention: the electronic components in the switch will cause the switch to warm up
slightly when the electric underblanket is being used. For this reason, the switch must ne-
ver lie on the electric underblanket or be covered by blankets, pillows etc.