EHEIM air pump 100 Bedienungsanleitung Seite 8

– To avoid injury, do not contact moving parts.
– Always unplug an appliance from an outlet when not in use, before put-
ting or taking off parts, and before cleaning. Never yank cord to pull plug
from outlet. Grasp the plug and pull to disconnect.
– Do not use an appliance for other than intended use. The use of attach-
ments not recommended or sold by the appliance manufacturer may
cause an unsafe condition.
– Do not install or store the appliance where it will be exposed to the we-
ather or to temperatures below freezing.
– Make sure an appliance mounted on a tank is securely installed before
operating it.
– Read and observe all the important notices on the appliance and its cord.
– If an extension cord is necessary, a cord with a proper rating should be
used. A cord rated for less amperes or watts than the appliance rating
may overheat. Care should be taken to arrange the cord so that it will not
be tripped over or pulled.
– Check that the voltage shown on the label of the unit corresponds to the
voltage of the mains supply.
– Disconnect all electrical appliances from the mains before placing hands
in the water.
– The line cord of this unit cannot be replaced or repaired. Should the line
cord become damaged the appliance must be discarded.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Thank you
for buying the new EHEIM auarium aerator. You have chosen aquality
product from EHEIM. The EHEIM air pump is finished to ahigh stan-
dard and is extremely reliable. The new housing designtype ensures
that noise is kept to the level of a whisper. YourEHEIM air pump is de-
livered complete with air hose and outlet andcan be used for a variety
of functions within the aquarium.
air pump 100 (Art.-No. 3701)
air pump 200 (Art.-No. 3702)
air pump 400 (Art.-No. 3704)
Model: see type plate on motor body