Petsafe 700 Series Montageanleitung Seite 5

Fitting the tunnel
Measure the
FIG. 6A
thickness (T) of
your door or wall.
Note this
measurement
(Fig. 6A). Cut the
grooved side of the
Left Support
plastic tunnel
pieces and tunnel
supports to equal
Left Support
the thickness (T) of
your door + 22 mm
FIG. 6B
(Fig. 6B). For
thicknesses (T)
FIG. 7B
greater than
54mm, the tunnel
FIG. 7A
provided cannot
be used.
Channel
Place cut edge
of bottom tunnel
piece toward you
with "T"-shaped rib
side facing up. Snap left tunnel support into
left end. Snap right tunnel support into right
end. With weather strip channels facing in,
align uncut edge (side with one rib) of side
tunnel pieces with uncut edge of supports.
Slide channels of side tunnel pieces onto tabs
of tunnel supports to form a "U"-shape (Fig. 7A).
Slide weather strips into channels of side tunnel pieces (Fig. 7B). Weather
strips should face inside. Weather strips may need trimming.
Left Support
Bottom
Right Support
Left Support
Right Support
Left Support Right Support
Bottom Side
Bottom
Top
Bottom Side
Bottom
Top
Top
Replacement flaps available online
FIG. 8
Right Support
Side
Right Support
Top
Optional
OPTIONAL:
Side
secure in place and to improve weather resistance. Cut off any
excess tape.
Top
Side
Fitting the pet door
Exterior Frame
Hex nuts
FIG. 9
Snap uncut edge (side with one rib) of
assembled tunnel pieces inside bottom
and side tabs of interior frame (frame
with 2 flaps). The bottom of tunnel
should be at bottom of interior frame.
Weather strips and ribbed sides (uncut
edges) should face flap. Snap the
uncut edge (side with one rib) of top
tunnel piece inside top tabs of interior
frame. Uncut edge (side with one rib)
of top tunnel piece should face flap.
Tunnel pieces may need trimming to
meet at corners (Fig. 8).
Use duct tape in the corners of tunnel to help
Helpful Tip:
A spare pair of
hands are useful at this point to
hold pieces together.
Interior Frame
Place interior frame with tunnel
assembly into cut-out. Next place
exterior frame into cut-out, inserting
tunnel inside tabs of frame. Hold
frame together. Insert nylon screws
through holes in interior frame into
holes in exterior frame. Thread a
hex nut onto each screw (Fig. 9).
Nylon Screws
5