Transportation; Moving; Transport Using A Crane; Transportation In Vehicle - WAGNER Plast Coat 830 Originalbetriebsanleitung

Plast Coat 830
5

TRANSPORTATION

5.1

MOVING

Roll up mains cable and remove hose.
Handles (fig. 4.1) are folded upwards.
To fold the handles inwards, turn them and then push down-
wards.
Make sure that 2 people are available to
carry the device on stairs.
5.2

TRANSPORT USING A CRANE

For attaching points for the straps or rope (not wire cable) see
figure.
5.3

TRANSPORTATION IN VEHICLE

-
6

COMMISSIONING

6.1

INSTALLATION LOCATION

1
6.1.1
CONNECTION TO MAINS POWER SUPPLY/
EXTENSION CABLE
Connection to the mains network only via a special feed-
ing point, for example via a distribution board for con-
struction sites, with residual current protective device
with INF ≤ 30 mA.
the line voltage matches that specified on the rating plate.
6.2

INITIAL STARTING-UP

6.2.1
SCOPE OF SUPPLY
individual components:
receptacle and transport frame with wheels
Stator
Hose package
Pump sliding means
To avoid material residues leaking from the
machine, clean the device in advance or lock
the mortar connection.
danger of stumbling.
Protect against damage, for example against
being driven over.
Min. wire cross-section 3 x 1.5 mm
coupling pieces and plugs are free of dam-
age.
GB
TRANSPORTATION
-
2
. Unroll the
37