Operation; Safety Instructions; Appliance Description; Troubleshooting - STIEBEL ELTRON SBP 200 E Bedienung Und Installation

OPERATION | INSTALLATION

Appliance description

The appliances SBP 200 E cool, SBP 400 E cool, SBP 700 E and
SBP 700 E SOL are also intended for seasonal (around 5 months
at a room temperature of 24 °C and relative humidity of 40 %)
storage of cooled heating water down to +7 °C. Constant cooling
operation with heating water below +11 °C is not permissible.
Any other or additional use is inappropriate, in particular
usage with alternative storage media. Correct use also includes
observation of the operating and installation instructions.
2.2

Safety instructions

Installation and commissioning must only be carried out by a
qualified heating contractor.
The heating contractor is responsible for adherence to all currently
applicable regulations during installation and commissioning.
Operate this appliance only if it is fully installed and all safety
equipment is fitted.
3. Appliance description
This appliance is designed to extend the operating time of the heat
source and to bridge power-OFF periods. It also enables hydraulic
separation of the volume flow of heat source and heating circuit.
SBP 200-400 E | SBP 200-400 E cool
To boost the heating water electrically, the installation of an
electric immersion heater is possible.
SBP 200 E cool | SBP 400 E cool | SBP 700 E | SBP 700 E Sol
These cylinders are equipped with complete thermal insulation to
protect against the formation of condensate.
SBP 700 E
For electric heating of the heating water, the installation of two
electric immersion heaters is possible. Additionally, a solid fuel
boiler may also be connected.
SBP 700 E SOL
The SBP 700 E SOL cylinder is additionally equipped with a smooth
tube heat exchanger for solar heating of the heating water.
4.

Troubleshooting

Call your qualified contractor. To facilitate and speed up your en-
quiry, please provide the serial number from the type plate (no.
000000-0000-000000):
www.stiebel-eltron.com

INSTALLATION

5.
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
5.1
We only guarantee trouble-free function and operational reliability
if the original accessories and spare parts intended for the
appliance are used.
6.
6.1
The standard delivery includes the following parts.
- Adjustable feet (only with SBP 200-400 E)
6.2
- immersion heater
- compact installation
7.
7.1
f Ensure the floor has a sufficient load bearing capacity (see f
chapter "Specification / Data table").
f Check the height of the room (see chapter "Specification / f
Data table").
Nr. 000000-0000-000000

Safety

General safety instructions

Appliance description

Standard delivery

Accessories

Installation

Installation site

SBP E | SBP E SOL | SBP E cool | 11