Troubleshooting - Electrolux TW SL6 E Benutzerinformation

24 www.electrolux.com
11.5 Cleaning the control panel
and housing
Use a standard neutral soap detergent to
clean the control panel and housing.
Use a moist cloth to clean. Dry the
cleaned surfaces with a soft cloth.
CAUTION!
Do not use furniture cleaning
agents or cleaning agents
which can cause corrosion to
clean the appliance.

12. TROUBLESHOOTING

Problem
The tumble dry-
er does not op-
erate.
Unsatisfactory
drying result.
Possible cause
1)
The tumble dryer is not connec-
ted to mains supply.
The loading door is opened.
The On/Off (Ein/Aus) button was
not pushed.
The Start/Pause button was not
pushed.
The appliance is in the standby
mode.
Incorrect programme selection.
The filter is clogged.
The Dry Plus (Trocken+) option
was in minimum level.
Too high volume of the load.
The airflow grill is clogged.
Dirt on the humidity sensor in the
drum.
Incorrect remaining laundry mois-
ture degree.
The heat exchanger is clogged.
11.6 Cleaning the airflow slots
Use a vacuum cleaner to remove the fluff
from the airflow slots.
Connect in at mains socket.
Check fuse in fuse box (domestic
installation).
Close the loading door.
Push the On/Off (Ein/Aus) button.
Push the Start/Pause button.
Push the On/Off (Ein/Aus) button.
Do the selection of the applicable
programme.
Clean the filter.
Change the Dry Plus (Trocken+)
option to the moderate or maxi-
4)
mum level.
Obey the maximum load volume.
Clean the airflow grill in the bot-
tom of the appliance.
Clean the front surface of the
drum.
Adjust remaining laundry moisture
degree.
Clean the heat exchanger.
Remedy
2)
3)
4)
5)
3)