ZUMEX MINEX Bedienungsanleitung Seite 36

• To replace the blade holder unit, first insert the interior part of it, ensuring that it
enters as far as it can go and then insert the clip on the external part (See figure 9). If
you find it difficult to replace, the machine might have stopped halfway through a
cycle. Keep the ON/OFF pressed (with the containers and cover correctly positioned)
until the machine stops and you will then be able to assemble the blade unit with no
difficulty and carry on operating.
• Do not forget to clean the fruit feeding area regularly (Fig. 1), as otherwise a waxy
layer could form that is very difficult to remove. To do this proceed as follows:
1
Unplug the machine from the mains.
2
Dismantle the ramp by pulling it upwards, it is only inserted (Fig. 1).
3
Dismantle the feeder tube by pulling it in the indicated direction (Fig. 13).
4
If it is very dirty, dismantle the counterweight and dispenser (Fig. 13).
5
Wipe the whole cavity with a cloth dampened with water and detergent that
is suitable for washing dishes. Clean the dismantled parts and then rinse with
running water to remove all traces of soap.
6
Assemble the parts in reverse order of assembly.
35