Pioneer S-DJ08 Bedienungsanleitung Seite 3

CAUTION
The switch on this unit will not completely shut off
all power from the AC outlet. Since the power cord
serves as the main disconnect device for the unit,
you will need to unplug it from the AC outlet to shut
down all power. Therefore, make sure the unit has
been installed so that the power cord can be easily
unplugged from the AC outlet in case of an accident.
To avoid fire hazard, the power cord should also be
unplugged from the AC outlet when left unused for a
long period of time (for example, when on vacation).
Before making or changing the connections,
switch off the power and disconnect the power
cord from the AC outlet.
UK and Singapore models only
Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified
service personnel.
IMPORTANT: THE MOULDED PLUG
This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 5 amp fuse is fitted in this plug.
Should the fuse need to be replaced, please ensure that the replacement fuse has a rating of 5 amps and that it is approved by ASTA or BSI to
BS1362.
Check for the ASTA mark
If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug
must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer.
If the fitted moulded plug is unsuitable for your socket outlet, then the fuse shall be removed and the plug cut off and disposed of
safely. There is a danger of severe electrical shock if the cut off plug is inserted into any 13 amp socket.
If a new plug is to be fitted, please observe the wiring code as shown below. If in any doubt, please consult a qualified electrician.
WARNING: THIS APPARATUS MUST BE EARTHED.
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in
your plug, proceed as follows;
The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked with the letter E or by
the earth symbol
The wire which is coloured BLUE must be connected to the terminal which is marked with the
letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the
letter L or coloured RED.
How to replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse.
D3-4-2-2-2a*_A1_En
D44-9-3_A1_En
or the BSI mark on the body of the fuse.
Green & Yellow : Earth Blue : Neutral
or coloured GREEN or GREEN-AND-YELLOW.
Magnetically Shielded Speaker System
This speaker system is magnetically shielded.
However, depending on the installation location, color
distortion may occur if the speaker system is installed
extremely close to the screen of a television set. If
this happens, turn the power switch of the television
set OFF, and turn it ON after 15 to 30 minutes. If the
problem persists, place the speaker system away
from the television set.
Do not attach these speakers to the wall or ceiling, as
they may cause injury in the event of a fall.
Pioneer is not responsible for any accidents or damage
that result from improper installation, misuse or
modification of the product, or natural disasters.
Brown : Live
SGK001a_A1_En
SGK002a_A1_En
SGK007*_A1_En
SGK008_A1_En
D3-4-2-1-2-1*_A2_En