Enar PH60 Bedienungsanleitung Seite 29

No power:
en
Starter functioning defectively
DIESEL ENGINE (AIR COOLED)
Problems with starting:
10
PH60, PH70, PH80
- Insufficient power
• Normal compression and no visible defect in ignition
Air filter defective

Carbon deposit in cylinder

Incorrect fuel level in carburettor

• Insufficient compression
(See "Compression insufficient" above)

• Compression is correct, but ignition is defective
There is water in the fuel

Sparking plug is dirty

Ignition coil is defective

Ignition coil keeps short-circuiting

• Vibrator is full of excess oil
- Engine overheated
• Carbon deposit in fuel chamber or exhaust vent
• Incorrect heat-producing capacity in sparking plug
• Cooling fins are dirty
- Rotation velocity fluctuates
• Regulator incorrectly set
• Regulator spring faulty
• Deficient fuel flow
• Air entering tube suction system
- Rotating part clogged with dust
- Helical spring faulty
A.- Insufficient compression
• No compression
Suction valve or exhaust valve defective

Decompression system incorrectly set

• There is little or virtually no compression
Contact of valve seating is defective

Piston ring is eroded

Cylinder is worn out

Surface of cylinder fitting and cylinder head defective


Seating of injector is loose
B.- Fuel injection in the combustion chamber is not functioning properly
• There is little or no flow of fuel
Air ventilation opening in tank lid is blocked

Pass of fuel filter is obstructed and the filter is blocked

Tap of fuel filter is closed

Air retention in tube (particularly when the tank is empty)

TAMPING RAMMERS