Localizing And Repairing Faults - Enar PH60 Bedienungsanleitung

5.5.8.
With diesel engine:
SVC2 service alarm: after 50 hours working the tachometer will show SVC2 alarm. Perform
prescribed maintenance. To reset press "RESET" three times and hold RESET until display shows
"RESET".
SVC Service alarm: After 250 hours tachometer will show alarm SVC. Perform prescribed
maintenance. To reset press "RESET" twice and hold RESET until display shows "RESET".

5.6 LOCALIZING AND REPAIRING FAULTS

PETROL ENGINE
Does not start:
TAMPING RAMMERS
Tachometer operation.
When the engine is shut off the display shows total run time, this time
cannot be reset. When engine is started the display shows revolutions
per minute.
To view partial job time press "SELECT". To reset job time push and
hold "SELECT" button until display shows "RESET" and hours
accumulated on the current job,
counter will reset to 0.
- There is fuel, but the sparking plug does not produce a spark
• There is electricity in the high-tension cable
 Sparking plug flecked
 Carbon deposit in the sparking plug
 Short-circuit due to insufficient insulation of the sparking plug
 Incorrect separation between electrodes
• There is no electricity in the high-tension cable
 Switch of detention button short-circuited
 Ignition coil defective
 Insulation of condenser deficient or short-circuited
 Ignition coil broken or short-circuited
• Compression satisfactory
 Incorrect fuel
 Water or dust has entered
 Defective air filter
- There is fuel, and the sparking plug does produce a spark
• Compression insufficient
 Inlet valve or exhaust valve stuck or defective
 Piston ring or cylinder worn out
 Cylinder head or sparking plug incorrectly fitted
 Cylinder head joint or sparking plug joint defective
• The clutch is blocked, causing vibrator to rotate when attempt is made to
start
• There is no fuel in the carburettor
Fuel tank is empty

Fuel tap is not correctly open

Fuel filter is blocked

Air ventilation opening in tank lid is blocked

Air retention in tube

Inlet valve of carburettor is stuck

PH60, PH70, PH80
When you release the button the
en
9