Sound And Vibration Measurements; Starting, Operation And Maintenance Of The Machinery; Before Starting Work; Starting Up The Machine - Enar PH60 Bedienungsanleitung

4

SOUND AND VIBRATION MEASUREMENTS

-
Level of acoustic power according to
- Level of acoustic pressure according to
- Weighted real value of axial acceleration according to EN 500-4 :
5 STARTING,
MACHINERY

5.1 BEFORE STARTING WORK

5.1.1.
level using the visor situated at the rear beneath the bellow. If oil cannot be seen through the visor,
add oil until half the visor is covered.
5.1.2.
with, according to the table below:
ENGINE TYPE
HONDA GX120
When filling the tank, be sure to filter the fuel with a strainer. Do not forget to replace the fuelling cap
and close it. Failure to do this is dangerous, as the vibration of the machine may cause spillages of
fuel that then ignite and burn.
5.1.3
loose due to vibration may unexpectedly cause a serious problem. Make sure that all screws are
tightened.
5.1.4.

5.2 STARTING UP THE MACHINE

5.2.1.
lever in the half-open position. To start the engine cold, move the air regulator lever to the closed
position. When the engine is hot, the air regulator should be half-open or completely open. If it
proves difficult to start the engine, make sure that the air regulator lever is half-open to prevent the
carburettor from flooding due to excess fuel.
5.2.2.
damage the spring. Do not suddenly release the rope in order to repeat the process once the engine
has started. Hold on to the rope, and slowly release until it has fully returned to position.
TAMPING RAMMERS
OPERATION
The mechanisms of this machine are lubricated by means of an oil bath. Check the oil
Fill the fuel tank with the appropriate type of fuel for the engine your machine is provided
HONDA GX100
UNLEAD PETROL
Be sure to check the tension of every bolt, nut or threaded area. A screw that has come
Remove all dirt and dust. Pay special attention to cleaning the area adjacent to the
starter and the leg.
Open the fuel tap by moving the air regulator lever downwards, and put the choke valve
When pulling the starter rope, do not apply full pressure for the whole length, as this may
PH60, PH70, PH80
EN 500-4: L 106 dB(A)
WA
EN 500-4: L
pA
AND MAINTENANCE
ROBIN ER12 ROBIN EH12
96 dB(A)
2
Ahv 6,8 m/s
OF
YANMAR L48
GAS-OIL A
TYPE OF FUEL
THE
en
5