Installation - simu T5 AUTO+JOB Originalanleitung

S.A.S. au capital de 5 000 000 ! - Z.I. Les Giranaux - BP71 - F70103 Arc-Les-Gray CEDEX - RCS VESOUL B 425 650 090 - SIRET 425 650 090 00011 - n° T.V.A CEE FR 87 425 650 090
These instructions apply to all T5 AUTO+JOB drives, in all torque/speed.
Field of application: The T5 AUTO+JOB drive is designed to drive all types of roller shutters equipped with stop blocks and rigid links. The installer, who must
be a motorisation and home automation professional, must ensure that the drive product is installed in accordance with the standards in force in the country in
which it is installed such as EN 13659 relating to roller shutters.
Liability: Please read these instructions carefully before installing and using the drive. In addition to following the instructions given in this guide, the
instructions detailed in the attached Safety instructions document must also be observed. The drive must be installed by a drive and home automation
professional, according to instructions from SIMU and the regulations applicable in the country in which it is commissioned. It is prohibited to use the drive
outside the fields of application described above. Such use, and any failure to comply with the instructions given in this guide and in the attached Safety
instructions document, absolves SIMU of any liability and invalidates the warranty. The installer must inform its customers of the operating and maintenance
conditions for the drive and must provide them with the instructions for use and maintenance, and the attached Safety instructions document, after installing
the. Any After-Sales Service operation on the drive must be performed by a drive and home automation professional. If in doubt when installing the drive, or to
obtain additional information, contact a SIMU adviser or go to the website www.simu.com
1

Installation

Instructions which must be followed by the drive and home automation professional installing the drive:
- Methods of wiring are given by national standards or IEC60364 standard.
- Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve.
- The cable for the T5 AUTO+JOB motor cannot be removed. If it is damaged, return the drive to the After-Sales department.
Recommendations: The motor torque must be selected according to the shutter's characteristics. Do not oversize the operator. The use
of automatic locking devices (VAR, VAS, EASYLINK or OCTOEASY) and stops on the final slat is mandatory in order to ensure proper
working of the motor. To receive information regarding the compatibility of the motor and the roller shutter or/and accessories, contact the
roller shutter manufacturer or SIMU.
Drilling of the tube:
50°
20°
T5 AUTO+JOB
230V-50Hz
Mounting:
V.A.R
V.A.S
EASYLINK
OCTOEASY
MANDATORY
T5 AUTO+JOB
(230V ˜ 50Hz)
L1
22,8
IP44
4
Ø6
L2
6/17
10/17
15/17
DEPRAT 53
T
min.
47
2
25 mm
2
1
25 mm
1/2
5124122B
EN- ORGINAL INSTRUCTIONS
i
A
A ØB L1
(mm) (mm) (mm)
455 476
466 5 487
486 507
OCTO. 50
2
PLASTITE
1
Ø4 x 15
OCTO. 60 - ZF 54 / 64 - DEPRAT 53 /62
2
Ø4 x 10
PLASTITE
Ø4 x 10
Ø 4,5
-20°C / +60°C
4 x ØB / 90°
L2
(mm)
499
510
530
Ø 2,5