Operation - Spit P18 Original Bedienungsanleitung

English
14
Device components
4. Depth stop
5. Belt hook
EN
Specified conditions of use
The device is designed exclusively for driving
screws into and
plasterboard and chipboard on wood and sheet
steel substructures.
Requirements for the user
The tool must only be operated, maintained and
serviced by authorised trained personnel. The
personnel must be made aware of the relevant
dangers.
Technical data
Rated voltage in V / Frequency in
HZ / Power rating P in watts
1. n
0
in rpm
Noise levels
L = A-rated sound pressure level
pA
L = A-rated sound power level
wA
K = Measurement uncertainty value
The noise level can exceed 85 dB(A)
during operation.
Wear hearing protection!
Couple max.
Nm
max.
Weight in kg
Fitting screws in wood - max. ø in mm
55014-2.
loosening screws
= No-load speed (1st gear)
Triaxial
determined in accordance with EN
60745.
K = Measurement uncertainty value.
The vibration emission level given in
this information sheet has been
from
measured in accordance with a
standardised test given in EN 60745
and may be used to compare one
tool with another.
The vibration emission level will vary
because of the ways in which a
power tool can be used and may
increase above the level given in
this information sheet. This could
lead to underestimation of vibration
when the tool is used regularly in
such a manner.
Note: To be accurate, an estimation
of the level of exposure to vibration
experienced during a given period of
work should also take into account
the times when the tool is switched
off and when it is running but not
actually when doing the job.
This may significantly reduce the
exposure level over the total working
period. Identify additional safety
measures to protect the operator
from the effects of vibration such as:
maintain the tool and accessories,
keep the hands warm, organisation
of work patterns.

4. Operation

Before carrying out any work on the device,
pull the mains plug.
SPIT P18
vibration emission level
EN