Niceboy PILOT Q3 Anleitung Seite 12

Language: The menu language can be set here.
Beeps: Activation/deactivation of button beeps.
Volume: Setting the volume of the sounds being recorded.
Display screen saver: Setting of the automatic screen deactivation.
Frequency: Setting the frequency.
G-Sensor: Setting of the G-Sensor intensity. G-Sensor will start up emergency recording in
response to shocks.
Parking mode: With the function activated the camcorder shall start up recording whenever
sensing shocks. It is necessary to deactivate the camcorder by means of the automatic
turn-off function upon power-off condition. The function is not active when the camcorder is
turned off manually (with the turn-off button).
Motion detection: Settings for motion detection. The camcorder will start up recording
whenever sensing a motion in front of its lens. The recording is deactivated when the motion
ceases. The motion detection works with the camcorder turned on and with the video loop
function deactivated. Use this function only on your car parked.
Erasure of settings: Back to camcorder factory setting.
Format: All the memory card data will be lost.
Date & time setting: Current date and time can be set here.
ADAS calibration: Setting for warning whenever you leave the traffic lane and in response
to too close distance to the vehicle ahead. Place the camcorder onto your automobile's
windscreen glass for calibration and follow the below steps:
1. Using the buttons 5 and 7 set the red line to become aligned with roadway horizon in
front of your vehicle. Then acknowledge the setting with the OK button.
2. Using the buttons 5 and 7 set the green line to become aligned with your
vehicle's hood.
3. Set the width for the traffic lane leaving warning with the buttons 5 and 7.
EN
12