Hitachi CP-WX625 Bedienungsanleitung Seite 138

Command Control via the Network (continued)
Command Format
[TCP #23]
1. Protocol
2. Header
3. Command data
Action
Action
1 Set
2 Get
4
5
6 Execute
Requesting projector status (Get command)
Header + Command data ('02H' + '00H' + type (2 bytes) + '00H' + '00H')
Changing the projector settings (Set command)
Header + Command data ('01H' + '00H' + type (2 bytes) + setting code (2 bytes))
Using the projector default settings (Reset Command)
Header + Command data ('06H' + '00H' + type (2 bytes) + '00H' + '00H')
Increasing the projector setting value (Increment command)
Header + Command data ('04H' + '00H' + type (2 bytes) + '00H' + '00H')
10
Content
Run a command.
Setting code
'1DH' + data (2 bytes)
'06H'
'06H'
'06H'