Optional Accessories - Makita BO3710 Bedienungsanleitung

Remove the pad for the conventional type of abrasive
paper from the tool with a screwdriver. Install the pad
for the hook-and-loop type of abrasive paper (optional
accessory) on the tool. Tighten the screws firmly to
secure the pad.
► Fig.6: 1. Abrasive paper 2. Pad
Remove all dirt or foreign matter from the pad. Attach
the paper to the pad, aligning the holes in the paper with
those in the pad.
► Fig.7: 1. O-ring
CAUTION:
• When removing the pad, O ring may come out
of the tool. When this occurs, return the O ring
to the original position and then install the pad.
Dust bag (optional accessory)
► Fig.8: 1. Dust spout 2. Dust bag
Attach the dust bag onto the dust spout. The dust spout
is tapered. When attaching the dust bag, push it onto
the dust spout firmly as far as it will go to prevent it from
coming off during operation.
For the best results, empty the dust bag when it
becomes approximately half full, tapping it lightly to
remove as much dust as possible.
Installing filter (Optional accessory)
► Fig.9: 1. Holding tab
Make sure that the logo on the cardboard lip and the logo on
the dust box are on the same side, then install the filter by
fitting the cardboard lip in the groove of each holding tab.
► Fig.10: 1. Dust box 2. Dust nozzle
Make sure that the logo on the cardboard lip and the
logo on the dust nozzle are on the same side, then
install the dust nozzle on the dust box. Removing dust
box and filter.
► Fig.11: 1. Latch 2. Dust nozzle
Remove the dust nozzle by pushing the two latches.
► Fig.12
Remove the filter first by pinching the logo side of its
cardboard lip, then by pulling the cardboard lip down-
wards to move it out of the holding tab of the dust box.
OPERATION
Sanding operation
► Fig.13
CAUTION:
• Never run the tool without the abrasive paper.
You may seriously damage the pad.
• Never force the tool. Excessive pressure may
decrease the sanding efficiency, damage the
abrasive paper or shorten tool life.
Hold the tool firmly. Turn the tool on and wait until it
attains full speed. Then gently place the tool on the
workpiece surface. Keep the pad flush with the work-
piece and apply slight pressure on the tool.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
NOTICE:
• Never use gasoline, benzine, thinner, alcohol or
the like. Discoloration, deformation or cracks may
result.
To maintain product SAFETY and RELIABILITY,
repairs, carbon brush inspection and replacement, any
other maintenance or adjustment should be performed
by Makita Authorized Service Centers, always using
Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
• These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Abrasive paper (with pre-punched holes)
• Hook-and-loop type of abrasive paper
• Punch plate
• Backing pad (For use with hook-and-loop type of
abrasive paper)
• Backing pad (For use with conventional type of
abrasive paper)
• Dust bag
• Dust box
• Filter
• Hose
NOTE:
• Some items in the list may be included in the
tool package as standard accessories. They
may differ from country to country.
6 ENGLISH