Specifications - Makita 9741 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Wing nut
1-2. Front roller
2-1. Switch trigger
2-2. Lock button
3-1. Spindle
3-2. Wheel
3-3. Output shaft

SPECIFICATIONS

Wheel size (Diameter x Width)
No load speed (min
Dimensions (L x W x H)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for removing paint with slit paper
wheel and fine metal cleaning with wire brush wheel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : sanding metal plate
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : sanding wood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
3-4. Hex wrench
4-1. Notch
4-2. Wheel
4-3. Spindle
4-4. Pin
5-1. Dust port
5-2. Cover plate
Model
-1
)
Net weight
Safety class
) : 89 dB(A)
pA
) : 100 dB(A)
WA
2
) : 5.5 m/s
h
2
2
) : 3.0 m/s
h
2
ENE053-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENF002-2
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
ENG905-1
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG900-1
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Wheel Sander
Model No./ Type: 9741
are of series production and
Conforms to the following European Directives:
2006/42/EC
3
5-3. Joint
6-1. Grip
6-2. Handle
7-1. Limit mark
8-1. Screwdriver
8-2. Brush holder cap
9741
100 mm x 120 mm
3,500
310 mm x 185 mm x 182 mm
4.2 kg
/II
Corporation as
ENG901-1
ENH101-15
the responsible