Commissioning - Schneider Airsystems UHW 2000 Original Bedienungsanleitung

GB
UHW
CAUTION
Dangerous obstacle!
Air hoses laid on the ground.
Avoid or pay close attention.
• Protect yourself and other persons, ani-
mals, property, and the environment by
taking the necessary protective measures
and being trained in use of the devices to
prevent harm to your health, property
damage, financial
harm or risk of accident.
• Be calm and focused and ensure proper
operation.
• Repairs may be carried out only by
Schneider Druckluft GmbH or its approved
service partners.
• Prohibited: manipulation, inappropriate
use, temporary repairs, use of other ener-
gy sources, removal or use of damaged
safety equipment, operating a leaking or
malfunctioning system, use of non-original
spare parts, exceeding the permitted
working pressure specified (max. + 10%),
working without protective equipment,
transporting / maintaining / repairing or
leaving a pressurised machine unattended,
using other / unsuitable lubricants, smok-
ing, naked flames, removing stickers.
• Prohibited: Smoking and naked flames.
• Prohibited: Processing corrosive fluids.
The compressed air device may corrode.
• Prohibited: Using explosive or flammable
cleaning agents; disposing of leftover ma-
terials / cleaning agents incorrectly.
• Prohibited: Use in medical / food indus-
try; incorrect processing equipment; spark
formation.
2.4

Commissioning

Before start-up:
1. Observe technical data, figures, item
numbers, intended use and safety in-
structions
II/ 8
loss, environmental
(see Instruction manual, Part 1, Chap-
ter: "Technical data" and the "Intended
use" chapter).
2. Carry out a visual inspection.
3. Do not use below 5° C.
4. Do not use cartridges under 15°C.
It is advisable to use cartridges at a tem-
perature between 15° and 20°C to ensure
the material is applied with maximum ef-
fect. Cold cartridges should be allowed to
acclimatise to the correct temperature.
Operation:
1. Adjust the working pressure on the filter
pressure reducer.
2. Press the trigger lever (item 02).
Underbody protection:
The standard equipment of the multi-pur-
pose gun includes a spray nozzle for under-
body protection. The intake pressure must
be adjusted on the depressurised device.
1. Screw the spray nozzle (item 10) on the
depressurised device all the way into the
multi-purpose gun (Fig. 2a, Fig. 2b).
2. Unscrew the nozzle another three turns
and fix in position using the counternut
(item 06) (Fig. 2c). Screw on the coun-
ternut up to the stop.
3. Screw on the cartridge with underbody
protection (Fig. 3a).
Increase the intake pressure if necessary:
the spray nozzle on the depressurised de-
vice must be screwed further in or out.
Cavity sealing:
1. Unscrew the spray nozzle (item 10) with
counternut (item 06) and the reduction
fitting (Fig. 4a) on the depressurised de-
vice.
2. Screw in the spray hose (item 11) in
place of the spray nozzle (Fig. 4b) up to
the stop.
3. Screw on the cartridge with cavity seal-
ing (Fig. 3a).
Note: the spray hose must be no longer
than 90 cm, otherwise the material will
not flow through the hose.
Only use thin material for cavity sealing!