Klarstein 10010174 Bedienungsanleitung Seite 15

2. Attach the photo, disassemble the tap;
3. Attach the photo, connect the tap with beer keg
4. Attach the photo, press the beer outlet valve, cover the lid
5. Pull the tap towards you standing, than you can taste fresh beer.
Attention: Before switching of the beer dispenser, always ensure that no 5 liter party keg is present in
the dispenser as the beer in the keg becomes warm and is no longer fresh
1. Preparing glasses:
2. Wash the glasses in hot water with a small amount of washing / up liquid. Rinse the glasses
thoroughly each time before dispensing with cold, clear water. Ensure that all grease and residues
are removed completely to avoid impairing foam formation.
Hold the glass under the beer tap at an angle. The tip of the outlet tube should not come into contact
with the glass as this can impair the foam formation.
Note: The foam produced when dispensing beer can be infl uenced by changing the angle of the glass.
Note: If the tap is only partly open, the beer may foam excessively as it is not able to fl ow out freely.
Note: The tap locks in position when the tap is fully open. This enables several glasses of beer to be
dispensed simultaneously.
15
Service
Dispensing beer