Zanussi ZWF 14010S Benutzerinformation Seite 13

A tune sounds when the appliance is activated. The
appliance performs a start up animation. The
animation quickly shows each washing programme
and the default temperature and spin settings.
The display shows the word On.
SETTING A PROGRAMME
1. Touch the programme button
programme:
• The indicator of the button
• The display shows the programme duration.
2. If necessary, change the temperature and the
spin speed or add available options. When you
activate an option, the indicator of the set
option comes on.
If you set something incorrect, the
display shows the message
STARTING A PROGRAMME WITHOUT THE
FERTIG UM/FINI À
Touch the button
• The indicator of the button
flash and stays on.
• The programme starts, the door locks, the
indicator
• The drain pump can operate for a short time
at the beginning of the washing cycle.
After approximately 15 minutes from
the start of the programme:
• The appliance adjusts automatically
the programme duration agree with
the laundry load.
• The display shows the new value.
STARTING A PROGRAMME WITH THE
FERTIG UM/FINI À
Check if the appliance has the correct hour set.
See in "Clock setting" how to set the appliances's
clock.
First set the programme (and add options) then set
the option .
1. Touch the button
time. With the first touch the time is rounded to
the nearest hour or to the nearest half an hour.
By each next touch the end time increases by
1) If you keep the button
and set the
flashes.
OPTION
.
stops to
is on.
OPTION
to set the desired end
pressed the digits change in a quicker way.
30 minutes segments until maximum range of
20 hours.
The display shows the finish hour you set (e.g.
) and the indicator
this option is active.
2. Touch the button
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically and the
actual programme duration counts down in
minutes until the cycle end.
You can cancel or change the set of
the option
button
.
To cancel the Fertig um/Fini à
a. Touch the button
to pause. The indicator of button
flashes.
b. Touch the button
the indicator
Touch the button
programme immediately.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Touch
The indicator of this button flashes.
2. Change the options.
If you change any option the
will be disabled.
3. Touch
The programme continues.
CANCELLING A PROGRAMME
1. Press the button
cancel the programme and to deactivate the
appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
1)
is on to show that
:
before you touch the
. After touching the button
you can only cancel the option
option:
to set the appliance
again and again until
goes off from the display.
again to start the
.
again.
for some seconds to
.
option (if set)
13