Machine Information; Technical Specifications - VONROC JS502AC Originalbetriebsanleitung

EN
• Only use saw blades that are suitable for use
with the machine.
• Only use saw blades with the correct dimensions.
• Do not use other accessories than saw blades.
• Do not use saw blades made of HSS steel.
• Do not use the machine on workpieces requi-
ring a maximum sawing depth that exceeds the
maximum sawing depth of the saw blade.
• Hold the machine by the insulated gripping
surfaces where the saw blade may contact hid-
den wiring or the mains cable. If the saw blade
contacts a 'live' wire, the exposed metal parts
of the machine can also become 'live'. Risk of
electric shock.
• Let the machine run at no load in a safe area
after mounting the saw blade. If the machine
vibrates strongly, immediately switch off the
machine, remove the mains plug from the
mains, and try to solve the problem.
• Beware that the saw blade continues to rotate
for a short period after switching off the machi-
ne. Do not attempt to bring the saw blade to a
standstill yourself.
Kickback
Kickback is the upward and backward movement
of the saw blade when the saw blade unexpectedly
touches an object. Securely hold the machine during
use. Keep your attention focused on the operation.
Kickback is usually caused by:
- unintentionally touching hard objects or
materials with the rotating saw blade;
- a blunt saw blade;
- a saw blade that is not properly mounted;
- sawing into a previous cut;
- a lack of attention to the operation;
- an instable stance.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable
for the power rating of the machine with a
minimum thickness of 1.5 mm
extension cable reel, always fully unroll the
cable.
6

2. MACHINE INFORMATION

Intended use
Your jigsaw has been designed for sawing wood,
metal, plastics, ceramics, rubber, etc. to any requi-
red size and in any required shape.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Power
No load speed
Max. sawing depth (wood)
Mitre angle
Sound pressure (Lpa)
Acoustic power (Lwa)
Vibration (wood)
Vibration (metal)
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2 - 3
. If you use an Fig. A
2
1. On/off switch
2. Lock-on button
JS502AC
230-240 V~
50Hz
550 W
0 - 3.000/min
65 mm
- 45 to 45°
85 dB(A) K=3dB
96 dB(A) K=3dB
11.71 m/s
8.81 m/s
Wear hearing protection.
WWW.VONROC.COM
K=1.5 m/s
2 2
K=1.5 m/s
2 2