Getting Started; Installing The Cutting Blade Assembly - HP Cricut Imagine Benutzerhandbuch

GettInG stArteD

Installing the Cutting Blade Assembly

Please note that the Cricut Imagine
tom of your box, separate from the machine. Before you turn the machine on, you
will need to insert the blade assembly. To do this:
1. Remove the cardboard inserts from both
sides of the carriage. open the front door
on the Cricut Imagine
move the blade carriage assembly to the
left by grasping the black cradle arm and
pulling the assembly toward the center of
the opening.
2. Remove the cutting blade assembly from
its bag. The blade assembly fits into the
black cradle on the left side of the carriage.
Rotate the adjustment knob on the top of
the blade assembly so that the black arrow
on the blade assembly points to the number
3 on the adjustment knob.
3. Locate the silver nut and turn it counter-
clockwise until it loosens enough that you
can swing the screw to the right. Be careful
not to loosen the screw too much or it will
fall out.
4. open the left arm of the black cradle and
position the cutting blade assembly inside
as shown with the black arrow facing you.
Ensure that the cutting blade has been
inserted into the assembly with the sharp
blade end pointing down. Close the cradle,
swing the nut back to the left, and tighten it
by turning it clockwise.
cutting blade assembly is located in the bot-
™
machine. Manually
™
GETTInG STARTED 7