Calibration; Positioning Your Cricut Imagine ™ Machine - HP Cricut Imagine Benutzerhandbuch

Calibration

Prior to your first use of your Cricut Imagine
tion routines. There are instructions on the screen which will direct you through
each calibration process.
The first calibration is a screen calibration and will not require any printing or cut-
ting. The next two calibrations will require you to put a 12" x 12" white piece of
paper on the mat and insert the mat into the machine. For assistance in mount-
ing paper on the mat for the first time, please see instructions on page 13. After
inserting the second piece of 12" x 12" white paper and the cut and print are
complete, the Cricut Imagine
the printed lines are cut most accurately. Click test Cut and the machine will begin
cutting. Examine the cut in the center of the page to determine if the cut stayed
inside the printed line. If the cut was successful in staying inside the printed line,
click the Accept button. If the cut was outside of the printed lines, select repeat
to run the test again. For more information on the Print & Cut calibrations, see the
instructions on page 32.
Positioning your Cricut Imagine
Place your Cricut Imagine
table to prevent it from tipping and causing possible injury. Allow 12" (30.48 cm) in
the back of the Cricut Imagine
When positioning your Cricut Imagine
• cannot be accessed by children. The Cricut Imagine
and contains components, including a sharp blade, that could be hazardous
to children.
• is a hard, stable, and flat surface within 6 feet (1.83 meters) of a grounded
electrical outlet, and that has a minimum clearance of 12" (30.48 cm) behind the
Cricut Imagine
™
• is indoors or in a dry location where the Cricut
exposed to the effects of the weather.
• is away from direct exposure to sunlight or extreme temperatures such as in
parked cars, storage sheds, sunrooms, etc.
WArnInG! Your Cricut Imagine
in locations without heat or air conditioning, or in environments where the ma-
chine or cartridges can come in contact with water. It is recommended your
Cricut Imagine be maintained in an area with temperatures between 60 and 90 °F
™
(15.5 and 32.2 °C).
10 GETTInG STARTED
will ask you to select a number and letter for which
™
Machine
™
machine at least 12" (30.48 cm) from the edge of your
™
machine for mat movement.
™
machine for paper movement.
machine should never be left or stored outside,
™
, t he machine will run three calibra-
™
machine, choose a location that:
™
™
cartridges are not directly
®
machine is not a toy