Caring For The Cutting Mat; Maintaining The Print Cartridges; Replacing A Print Cartridge - HP Cricut Imagine Benutzerhandbuch

WArnInG! Cutting blades are extremely sharp and should be handled with the
utmost care. They are also potential choking hazards; they should be kept away
from children.

Caring for the Cutting Mat

You can expect anywhere from 25 to 40 full mat cuts (expect even more when a
cut is smaller than the full mat) from your Cricut Imagine
requires replacement. Your actual cutting mat life will vary, depending on the set-
tings you use and the papers you cut. It is time to replace your mat when:
• your paper no longer sticks to the cutting mat.
• the mat becomes curled on the edges, which will affect the accuracy of the
print-to-cut alignment.
Use only genuine Cricut Imagine
everywhere (part #2000784).

Maintaining the Print Cartridges

The following tips will help maintain the Cricut Imagine
ensure consistent print quality:
• Keep all print cartridges in their sealed packages until they are needed.
Print cartridges should be stored at room temperatures between 59 and 95 °F
(15 and 35 °C).
• Do not remove the plastic tape covering the ink nozzles until you are ready to
install the print cartridge in the printer. If the plastic tape has been removed
from the print cartridge, do not attempt to reattach it. Reattaching the tape
damages the print cartridge.
WArnInG! Do not drop the print cartridge. Dropping the print cartridge may
damage it.

replacing a Print Cartridge

1. Turn on the Cricut Imagine
on the back of the machine and lift the print latch for the cartridge you will
be replacing.
2. Grasp the installed print cartridge and slide it out of its cradle.
CAUtIon: To prevent clogs, ink failure, and bad electrical connections, do not
touch the print cartridge ink nozzles or copper contacts, and do not remove the
copper contacts.
replacement cutting mats, available at retailers
™
, open the print cartridge access door located
™
cutting mat before it
™
print cartridges and
™
BASIC CARE 21