Grundfos MAGNA UPE-Serie 2000 Montageanleitung Seite 30

3. Fit the module.
n
o
4. Connect the cables.
Cable specifications are stated in section 5. Technical data .
A wiring diagram can be found on page 37.
• Wires connected to
- outputs NC, NO, C,
- inputs Start/stop, A, B and
- supply terminals
must be separated from each other and from the supply by
reinforced insulation.
• All wires connected to a terminal block must be tied up at the
terminals.
5. Switch on the electricity supply.
30