Atag KA2411L Benutzerinformation Seite 19

Switching off the wine cooler
compartment
1. Press Mode until the corresponding
icon appears.
The wine cooler compartment indicators
flash.
The wine cooler compartment temperature
indicator shows dashes.
2. Press OK to confirm.
The wine cooler compartment Off indicator
is shown.
Switching on the wine cooler
compartment
1. Press Mode until the corresponding
icon appears.
The wine cooler compartment Off indicator
flashes.
2. Press OK to confirm.
The wine cooler compartment Off indicator
goes off.
To select a different set temperature refer to
"Temperature regulation".
Temperature regulation
Set the temperature of the wine cooler
compartment and of the Freezer
compartment by pressing the temperature
regulators.
The temperature in the wine cooler
compartment can be adjusted between
+6°C and +16°C.
Default temperature settings:
• +10°C for the wine cooler
compartment
• -18°C for the freezer compartment
The set temperature will be reached within
24 hours.
After a power failure the set temperature
remains stored.
FastFreeze function
The FastFreeze function accelerates the
freezing of fresh food and, at the same
time, protects foodstuffs already stored
from undesirable warming.
1. To activate this function press the
Functions button until the
corresponding icon appears.
The FastFreeze indicator flashes.
2. Press the OK button to confirm.
TheFastFreeze indicator is shown.
This function stops automatically after 52
hours.
To switch off the function before its
automatic end repeat the procedure until
the FastFreeze indicator turns off.
The function switches off by
selecting a different set
temperature.
High temperature alarm
An increase in the temperature in the
freezer compartment (for example due to
an earlier power failure) is indicated by
flashing the alarm icon and freezer
temperature indicators, and sounding of
buzzer.
Press any button.
The buzzer switches off.
The freezer temperature indicator shows
the highest temperature reached for a few
seconds, then displays the set temperature
again.
The alarm indicator continues to
flash until the normal conditions
are restored.
Door open alarm
An acoustic alarm will sound if the door is
left open for approximately 5 minutes. The
door open alarm conditions are indicated
by:
• flashing alarm indicator;
• acoustic buzzer.
When normal conditions are restored (door
closed), the alarm will stop. During the
alarm, the buzzer can be switched off by
pressing any button.
ChildLock function
Activate the ChildLock function to lock the
buttons from unintentional operation.
19