Kenwood multione KHH30 Bedienungsanleitungen Seite 14

to use the cutting discs
1 Fit the bowl on the power unit, add the detachable
drive shaft.
2 Hold by the finger grip, place the disc onto the
drive shaft with the appropriate side uppermost.
3 Fit the lid.
4 Put the food in the feed tube.
5 Switch on, then push down evenly with the pusher
– never put your fingers in the feed tube.
hints
Use fresh ingredients.
l
Do not cut food too small. Fill the width of the feed
l
tube fairly full. This prevents the food from slipping
sideways during processing.
Food placed upright comes out shorter than food
l
placed horizontally.
There will always be a small amount of waste on
l
the disc or in the bowl after processing.
citrus juicer
br
Use the citrus juicer to squeeze the juice from
citrus fruits (e.g. oranges, lemons, limes and
grapefruits).
cone
A
B sieve
to use the citrus juicer
1 Fit the bowl onto the outlet
drive shaft.
2 Fit the sieve into the bowl – ensuring the sieve
handle is locked into position directly over the bowl
handle .
bo
3 Place the cone over the drive shaft turning until it
drops all the way down
4 Cut the fruit in half. Then switch on and press the
fruit onto the cone.
The citrus juicer will not operate if the
l
sieve is not locked correctly.
For best results store and juice the fruit at room
l
temperature and hand roll on a worktop before
juicing.
To help with juice extraction move the fruit from
l
side to side when juicing.
When juicing large quantities, empty the strainer
l
regularly to prevent the build up of pulp and seeds.
(if supplied)
, add the detachable
2
.
bp
glass blender
bs
A filler cap
lid
B
C goblet
sealing ring
D
blade unit
E
to use your glass blender
1 Fit the sealing ring
ensuring the seal is located correctly in the grooved
area.
Leaking will occur if the seal is damaged
l
or incorrectly fitted.
2 Screw the goblet onto the blade assembly
Refer to the graphics on the underside of the blade
unit as follows:
- unlocked position
- locked position
The blender will not operate if incorrectly
assembled.
3 Put your ingredients into the goblet.
4 Fit the lid to the goblet and push down to secure
. Fit the filler cap.
br
5 Remove the dual drive outlet cover by turning it
anti-clockwise and lifting off.
6 Place the blender onto the power unit, and turn
clockwise until it clicks into position.
bs
The appliance will not operate if the
l
blender is incorrectly fitted to the
interlock.
7 Select a speed (refer to recommended speed
chart) or use pulse
hints
When making mayonnaise, put all the ingredients,
l
except the oil, into the blender. Remove the filler
cap. Then, with the appliance running, add the oil
slowly through the hole in the lid.
Thick mixtures, e.g. pâtés and dips, may need
l
scraping down. If the mixture is difficult to process,
add more liquid.
Ice crushing – operate the pulse in short bursts
l
until crushed to the desired consistency.
The processing of spices is not recommended as
l
they may damage the plastic parts.
The appliance will not work if the blender
l
is incorrectly fitted.
9
(if supplied)
into the blade unit
D E
for short bursts.
P
-
.
bq