Herunterladen Inhalt Inhalt Diese Seite drucken

Service Data; Installation - Zanussi ZCV55001WA Benutzerinformation

Vorschau ausblenden Andere Handbücher für ZCV55001WA:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Problem
The oven / hob display shows
an error code that is not in this
table.
You cannot activate or operate
the hob.
Residual heat indicator does
not come on.
The lamp does not operate.
Steam and condensation settle
on the food and in the cavity of
the oven.
The oven does not heat up.
It takes too long to cook the
dishes or they cook too quick-
ly.

Service data

If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

Installation

WARNING!
Refer to Safety chapters.
www.zanussi.com
Possible cause
There is an electrical fault.
The fuse is released.
The zone is not hot because it
operated only for a short time.
The lamp is defective.
You left the dish in the oven for
too long.
The necessary settings are not
set.
The temperature is too low or
too high.
We recommend that you write the data here:
Deactivate the appliance with
the house fuse or the safety
switch in the fuse box and acti-
vate it again.
If the display shows the error
code again, contact the Cus-
tomer Care Department.
Activate the hob again and set
the heat setting in less than 10
seconds.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
Replace the lamp.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
Make sure that the settings are
correct.
Adjust the temperature if nec-
essary. Follow the advice in
the user manual.
The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the appliance cavity. Do not remove
the rating plate from the appliance cavity.
.........................................
.........................................
.........................................
Location of the appliance
You can install your freestanding appliance with
cabinets on one or two sides and in the corner.
For minimal distances for fitting check the table.
Remedy
17

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis