Batch Mode; Sort» Mode - Counts And Controls Banknotes Denomination - AUS Pro86 Mix Euro Bedienungsanleitung

- Display will show the quantity of counted banknotes
- Repeat again up to Table 8.1, when necessary
- Press and the «START» button to reset display when finished.
If an error occurs during counting, see Table "Error codes"

8.2. Batch mode

- Enter a number corresponding to the amount of banknotes for the desired batch size on the
display. To enter the value, press the button «BATCH» several times. To adjust the BATCH
value use buttons «+10», «+1» , «-1». The set batch value is indicated in the upper left
corner (Figure 8).
Fig.8
- Repeat the operation once again under cl. 8.1
- Remove banknotes from the stacker
-Add banknotes if necessary
In order to exit the batch mode, press the «BATCH» button several times till the display is
reset.
-If an error occurs during counting, repeat all these operations once again under cl. 8.2.
This mode works for all counting modes.
8.3. Summation mode
Press the "ADD" button to enter the summation mode. If the summation mode is on, the
"ADD" indicator is be lit (Figure 8).
- Repeat the operation once again under cl. 8.1
- Remove banknotes from the stacker
-Add banknotes if necessary
- Press the "ADD" button to exit the summation button, the indicator "ADD" is not lit.
- If an error occurs during counting, repeat summation once again.
This mode works for all counting modes.
9 «SORT» mode – counts and controls banknotes
denomination
Fig.9
This counting mode counts and recognizes EURO banknotes' denominations (determined by
the first banknote's denomination in a stack) and rejects banknotes with other denominations.
The display shows detections included into MT, MG, UV, DEN.
In this mode, the counter is sensitive to proper placement of the banknotes, irrelevant marks,
9